Range of densities

Density 100 kg/m³
NEOPOR^® offers the only system world-wide to produce a solely mineral-based insulation board offering the same lambda as man-made polystyrol, poly-urethane or mineral wool, however without any hazardous behaviour for health, environment or fire. This density requires autoclaving. Complete plants are available to produce up to 500 m³ daily (or more).

Density 300-600 kg/m³
This density is primarily applied for thermal insulation or fire protection. It uses only cement (or little sand), water and foam and can easily be pumped. NEOPOR^®'s foam generators allow the production of stiff foam for slopes to be applied on roof-tops.

Density 700-800 kg/m³
Is also used for void-filling, such as an landscaping (above underground construction), to fill voids behind archways and refurbishing of damaged sewerage systems. It is also been used to produce building blocks.

Density 900-1100 kg/m³
Serves to foremostly produce blocks and other non-load bearing building elements such as balcony railings, partitions, parapets and fence walls etc.

Density 1200-1400 kg/m³
Are the most commenly densities for prefab and cast in situ walls, load-bearing and non-load-bearing. It is also successfully used for floorscreeds (sound and insulation plus weight reduction).

Density 1600-1800 kg/m³
would be recommended for slabs and other load-bearing building elements where higher strength is obligatory.